DBK 45.107.08, Original Operating Instructions

11

GB

Timely recharging of the battery pack will help it
serve you well for a long time. You must recharge
the battery pack when you notice that the power of
the screwdriver drops.

Never allow the battery pack to become fully
discharged. This will cause it to develop a defect.

7.2 ON/OFF changeover switch (Fig. 3/Item 2)

You can select between clockwise and counter-
clockwise rotation.
Change the direction of rotation only when the
equipment is at a standstill. If you fail to observe this
point, the gearing may become damaged.

7.3 LED lamp (Fig. 1//Item 5)

The LED lamp (5) can be used in poor lighting
conditions to illuminate the area where you want to
screw. To switch on, push the switch (6) forwards; to
switch off, pull the switch back again.

7.4 Changing the tool (Fig. 5)
Important!

Insert the bit (A) into the bit chuck (1).
To remove the bit (A), pull it back out of the bit chuck
(1).

7.5 Screwdriving

We recommend using self-centering screws (e.g.
Torx screws, recessed head screws) designed for
reliable working. Be sure to use a bit that matches
the screw in shape and size. Set the torque, as
described elsewhere in these operating instructions,
to suit the size of screw.

7.6 Battery capacity indicator (Fig. 4/Item 7)

Press the battery capacity indicator switch (a). The
battery capacity indicator (7) indicates the charge
state of the battery on 3 colored LEDs.

All LEDs are lit:

The battery is fully charged.

The yellow and red LEDs are lit:

The battery has an adequate remaining charge.

Red LED:

The battery is empty, recharge the battery.

8.  Cleaning, maintenance and ordering

of spare parts

Always pull out the mains power plug before starting
any cleaning work.

8.1 Cleaning

Keep all safety devices, air vents and the motor 
housing free of dirt and dust as far as possible. 
Wipe the equipment with a clean cloth or blow it 
with compressed air at low pressure.

We recommend that you clean the device 
immediately each time you have finished using it.

Clean the equipment regularly with a moist cloth 
and some soft soap. Do not use cleaning agents 
or solvents; these could attack the plastic parts
of the equipment. Ensure that no water can seep
into the device.

8.2 Maintenance

There are no parts inside the equipment which 
require additional maintenance.

8.3 Ordering replacement parts

Please quote the following data when ordering
replacement parts:

Type of machine

Article number of the machine

Identification number of the machine

Replacement part number of the part required

9. Storage

Store the equipment and accessories out of children’s
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.

10. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.

Anleitung_CSE_4_8_D_SPK7:_  20.07.2010  10:15 Uhr  Seite 11