DBK 45.131.57, Original Operating Instructions

11

GB

Wear ear-muffs.

The impact of noise can cause damage to hearing.

Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.

Drilling in concrete

Vibration emission value a

h

≤

 2,5 m/s

2

K uncertainty = 1,5 m/s

2

Screwing without hammer action

Vibration emission value a

h

≤

 2,5 m/s

2

K uncertainty = 1,5 m/s

2

Additional information for electric power tools

Warning!

The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.

The specified vibration value can be used to compare
the equipment with other electric power tools.

The specified vibration value can be used for initial
assessment of a harmful effect.

Keep the noise emissions and vibrations to a
minimum.

Only use appliances which are in perfect working
order.

Service and clean the appliance regularly.

Adapt your working style to suit the appliance.

Do not overload the appliance.

Have the appliance serviced whenever
necessary.

Switch the appliance off when it is not in use.

Wear protective gloves.

Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment’s
construction and layout:

1.  Lung damage if no suitable protective dust mask

is used.

2.  Damage to hearing if no suitable ear protection is

used.

3.  Health damage caused by hand-arm vibrations if

the equipment is used over a prolonged period or
is not properly guided and maintained.

5. Before starting the equipment

Be sure to read the following information before you
use your cordless screwdriver for the first time:
1.

Charge the battery pack only with the charger
supplied.

2.  Only ever use sharp drill bits and screwdriver bits

which are suitable for the purpose and in
faultless condition.

3.  Always check for concealed electric cables and

gas and water pipes when drilling and screwing
in walls.

6. Operation

6.1 Charging the battery pack (Fig. 2/3)

1.

Take the rechargeable battery pack out of the
handle (Fig. 2), pressing the pushlock buttons at
the side to do so.

2.

Check that your mains voltage is the same as that
marked on the rating plate of the battery charger.
Plug the battery charger in the socket.

3. Plug the battery pack into the charging adapter.

The LED (a) will come on to indicate that the
battery pack is being charged. The temperature
of the battery pack may rise slightly during the
charging operation. This is normal.

Important! The battery charger does not
switch off automatically when the battery is
fully charged.

If the battery pack fails to become charged, please
check

whether there is voltage at the socket-outlet

whether there is proper contact at the charging
contacts on the charger.

If the battery still fails to become charged, please
return

the charger

the battery pack

to our Customer Service Department.

To ensure that the battery pack provides long service,
you should take care to recharge it promptly. You
must recharge the battery pack when you notice that
the power of the cordless screwdriver drops.

Never fully discharge the battery pack. This will cause
it to develop a defect!

Anleitung_EAS_14_4_2B_SPK7:_  01.06.2010  8:49 Uhr  Seite 11