ROIP302 Series User menu
be set to other DDNS server; this setting only works with our own DDNS server. Once
this service is used, the domain name for the RoIP is then <serial number>.com. The serial
number is shown on the bottom label.
5.Remote Control – This option allows a user to access the RoIP’s webpage directly from our
remote control server.
6.4
Network
Proper network environment is the key to insure the performance of the RoIP302. normal For
best performance, it is recommended to connect the RoIP302 to a network with a static IP. In
general, this kind of network access offers higher bandwidth utilization. The next preferred
network access method is ADSL / Cable modem with PPPoE dial up for dynamic IP allocation.
The worst is the sharing private network via a router. The performance of RoIP302 depends greatly
on the bandwidth usage. In this case, it is best to configure the router to DMZ mode to the IP of the
RoIP302.
In order to get network access, the LAN port must be configured according to the network
environment to be connected. There are 3 access methods available for the LAN port
configuration.
1. Static IP – This mode applies to both public and private IP network environment. In the LAN
port configuration shown below, select “Static IP” and then fill in the parameters as provided by
your network administrator.
2. DHCP – When the RoIP302 is installed behind NAT and a DHCP host is available, select this
mode will enable the device to obtain LAN IP address and other network IPs automatically.
3. PPPoE – For most ADSL and Cable modem access method, the PPPoE dial up is normally used.
If the RoIP is connected directly to an access modem, you may need to select the PPPoE.
Please consult your ISP for further information if needed. Fill in the User Name and Password
www.dbltek.com
