www.dbtechnologies.com
info@dbtechnologies
Ͳ
aeb.com
B
Ͳ
HYPE
MOBILE
cod.
420120272Q
REV.1.2
Quick start user manual
Section 1
The warnings in this manual must be observed together with the "USER MANUAL - Section 2"
.
Le avvertenze nel presente manuale devono essere osservate congiuntamente al “MANUALE D’USO - Sezione2”.
Die Warnungen in diesem Handbuch müssen in Verbindung mit der "BEDIENUNGSANLEITUNG - Abschnitt 2" beobachtet
werden”.
Les avertissements specifiés dans ce manuel doivent être respectés ainsi que les "CARACTERISTIQUES TECHNIQUES -
Section 2"
Las advertencias del presente manual se deben tener en cuenta conjuntamente con las del “MANUAL DEL USUARIO” -
Sección 2”.
A.E.B. Industriale Srl Via Brodolini, 8 Località Crespellano 40053 VALSAMOGGIA BOLOGNA (ITALIA)
Tel +39 051 969870 Fax +39 051 969725 www.dbtechnologies.com info@dbtechnologies-aeb.com
www.dbtechnologies.com
info@dbtechnologies
Ͳ
aeb.com
B
Ͳ
HYPE
MOBILE
cod.
420120272Q
REV.1.2
Technical Data
Speaker Type
:
2-way battery speaker with wireless
microphone (handheld or bodypack versions)
Acoustical data
Frequency Response [-10 dB]
:
62 – 20000 Hz
Frequency Response [-6 dB]
:
66 – 18100 Hz
Max SPL (1 m)
:
123 dB
HF compression driver
:
1" Exit
(voice coil
:
1”)
LF
:
10” (
voice coil
:
1.5”)
Crossover frequency
:
2400 Hz
Dispersion
:
90° (H) x 45° (V)
Amplifier
Amp Technology
:
Amp SMPS Power Supply
Amp Class
:
Class-D
RMS Power
:
95 W
Peak Power:
190 W
Cooling:
Passive (convection)
Operating voltage range:
220-240V~/100-120V~ 50-60 Hz (factory set)
Operating temperature: [
-10 +55] °C
Charger operating temperature: [
-0 +44] °C
B-HYPE MOBILE battery
Battery type
:
LI-Ion (25.9 V / 2200 mAh)
Charging time:
Less than 2 hours
Mean usage time:
4 hours
Integrated transmitter Charger
Rechargeable Device:
HT-BHM handheld only (Ni-MH
rechargeable batteries only)
Audio Media Player
Supported audio formats:
.mp3, .wav, .wma
RF section
Available bands:
542-566 / 638-662 / 863-865 MHz
(factory set)
RF selectable channels:
8
Transmission range:
up to 35 m (114.82 in)
Input / Output
Mains connections
:
VDE
Signal I/O
: (
Balanced) 1x combo (XLR/TRS) IN, 1x stereo
RCA IN, 1x mini-jack IN, 1 x TRS link OUT
Mixer controls:
Volume controls, EQ, CH1/RF priority
Mechanics
Housing:
Plastic cabinet
Grille
:
Full grille
Handles
:
1 for each side, 1 on top (retractable)
Mounting pole:
yes, 36 mm
Width
:
300 mm (11.81 in)
Height
:
568 mm (22.36 in)
Depth
:
301 mm (11.86 in)
Weight (without transmitter)
:
12.5 kg (27 lbs.)
Download the complete user manual on:
www.dbtechnologies.com/EN/Downloads.aspx
, or scan with your QR Reader App to download it.
EMI CLASSIFICATION
According to the standards EN 55103 this equipment is designed and suitable to operate in CLASS B Electromagnetic environments.
FCC CLASS B STATEMENT ACCORDING TO TITLE 47, PART 15, SUBPART B, §15.105
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
B-HYPE MOBILE contains transmitter module:
HANDHELD VERSION
Æ
FCC ID:2ADDV-HTBHM (USA) IC:12207A-HTBHM (CANADA)
BODYPACK VERSION
Æ
FCC ID: 2ADDV-BTBHM (USA) IC: 12207A-BTBHM (CANADA)
WARNING:
Make sure that the loudspeaker is securely installed in a stable position to avoid any injuries or damages to persons or properties. For safety reasons
do not place one loudspeaker on top of another without proper fastening systems. Before hanging the loudspeaker check all the components for damages,
deformations, missing or damaged parts that may compromise safety during installation. If you use the loudspeakers outdoor avoid spots exposed to bad weather
conditions.
Contact dB Technologies for accessories to be used with speakers. dBTechnologies will not accept any responsibility for damages caused by inappropriate accessories
or additional devices.
Features, specification and appearance of products are subject to change without notice.
dBTechnologies reserves the right to make changes or improvements in
design or manufacturing without assuming any obligation to change or improve products previously manufactured.
The Bluetooth
word mark and logos are registered trademarks owned by
Bluetooth
SIG, Inc. and any use of such marks by AEB Industriale SRL is under
license. Other Trademarks and trade names are those of their respective owners.
POWER SUPPLY SPECIFICATIONS (POWER ABSORPTION)
Draw at 1/8 of full power in average use conditions (*): 0.35 A (220-240V~) - 0.57 A (100-120V~)
Draw at 1/3 of full power in maximum use conditions (**): 0.65 A (220-240V~) - 1.3 A (100-120V~)
Power absorption with speaker turned on without signal (idle): 16 W
* INSTALLER NOTES: The values refer to 1/8 of full power, in average operating conditions (music program with
infrequent or no clipping). It is recommended to consider them the minimum sizing values for any type of
configuration.
** INSTALLER NOTES: The values refer to 1/3 of full power, in heavy operating conditions (music program with
frequent clipping or activation of the limiter).
