background image

www.dbtechnologies.com

 info@dbtechnologies-aeb.com

 

 

 

SUB 915                                                                                                                                            420120322Q REV 1.0 

 
 
 
 
 
 
 
 
 
 
 
 

 

 
 
 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
 
 
 
 
 
 
 
 

Quick start user manual 

Section 1 

 

 
The warnings in this manual must be observed together with the "USER MANUAL - Section 2"

Le avvertenze nel presente manuale devono essere osservate congiuntamente al “MANUALE D’USO – Sezione 2”.  

Die Warnungen in diesem Handbuch müssen in Verbindung mit der "BEDIENUNGSANLEITUNG - Abschnitt 2" beobachtet 
werden”.  

Les avertissements specifiés dans ce manuel doivent être respectés ainsi que les "CARACTERISTIQUES TECHNIQUES -
Section 2" 

Las advertencias del presente manual se deben tener en cuenta conjuntamente con las del “MANUAL DEL USUARIO” - 
Sección 2”.

 

 

A.E.B. Industriale Srl Via Brodolini, 8 Località Crespellano 40053 VALSAMOGGIA BOLOGNA (ITALIA)                          
 Tel +39 051 969870 Fax +39 051 969725 www.dbtechnologies.com info@dbtechnologies-aeb.com

 

 

 

 

Summary of Contents for SUB915

Page 1: ... in diesem Handbuch müssen in Verbindung mit der BEDIENUNGSANLEITUNG Abschnitt 2 beobachtet werden Les avertissements specifiés dans ce manuel doivent être respectés ainsi que les CARACTERISTIQUES TECHNIQUES Section 2 Las advertencias del presente manual se deben tener en cuenta conjuntamente con las del MANUAL DEL USUARIO Sección 2 A E B Industriale Srl Via Brodolini 8 Località Crespellano 40053 ...

Page 2: ...The box contains No 1 SUB 915 No 1 Mains cable with Neutrik powerCON TRUE1 connector No 1 Fuse for 100 120V usage This quick start and warranty documentation 2 Easy installation The easy use in different configurations is guaranteed by handles A pole mount adapters B amplifier C A usage example is represented here following for information only Please refer to the accessories instructions and SUB ...

Page 3: ...ontroller RDNet Control 2 or RDNet Control 8 with cables equipped with etherCON connectors Then connect the Data Output 4 to the Data Input 3 of a possible second device and so on When the RDNet network is on and it has recognized the connected device the LED Link 5 is on The other LEDs 5 Active start blinking at the presence of data transmission the Remote Preset Active advise that all the local ...

Page 4: ... in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more ...

Reviews: