dbx 20 Series, Operation Manual

U.K. MAINS PLUG WARNING

A molded mains plug that has been cut off from the cord is unsafe.
Discard the mains plug at a suitable disposal facility.  NEVER UNDER
ANY CIRCUMSTANCES SHOULD YOU INSERT A DAMAGED OR CUT
MAINS PLUG INTO A 13 AMP POWER SOCKET.  Do not use the
mains plug without the fuse cover in place.  Replacement fuse cov-
ers can be obtained from your local retailer.  Replacement fuses are
13 amps and MUST be ASTA approved 

to BS1362.

LITHIUM BATTERY

WARNING

CAUTION!

This product may contain a lithium battery. There is danger of
explosion if the battery is incorrectly replaced. Replace only
with an Eveready CR 2032 or equivalent. Make sure the bat-
tery is installed with the correct polarity. Discard used batter-
ies according to manufacturer’s instructions.

ADVARSEL!

Lithiumbatteri - Eksplosjonsfare. Ved utskifting benyttes kun
batteri som anbefalt av apparatfabrikanten.  Brukt batteri
returneres apparatleverandøren.

ADVARSEL!

Lithiumbatteri - Eksplosionsfare ved fejlagtig håndtering.
Udskiftning må kun ske med batteri av samme fabrikat og
type. Levér det brugte batteri tilbage til leverandøren.

VAROITUS!

Paristo voi räjähtää, jos se on virheellisesti asennettu. Vaihda
paristo ainoastaan laitevalmistajan suosittelemaan tyyppin.
Hävitä käytetty paristo valmistajan ohjeiden mukaisesti.

VARNING!

Explosionsfara vid felaktigt batteribyte. Använd samma batteri-
typ eller en ekvivalent typ som rekommenderas av apparattil-
lverkaren. Kassera använt batteri enligt fabrikantens instruk-
tion.

IMPORTANT SAFETY INSTRUCTIONS

ELECTROMAGNETIC

COMPATIBILITY 

This unit conforms to the Product

Specifications noted on the Declaration of

Conformity.  Operation is subject to the fol-

lowing two conditions:

• this device may not cause harmful inter-

ference, and 

• this device must accept any interference

received, including interference that may

cause undesired operation.  

Operation of this unit within significant elec-

tromagnetic fields should be avoided.

• use only shielded interconnecting cables.

DECLARATION OF

CONFORMITY

Manufacturer’s Name:

dbx Professional Products

Manufacturer’s Address:

8760 S. Sandy Parkway
Sandy, Utah 84070, USA

declares that the product:

Product name:

dbx 2031, dbx2215 and dbx2231
Note: Product name may be suffixed by
the letters-EU.

Product option:

None

conforms to the following Product Specifications:

Safety:

IEC 60065 (1998)

EMC:

EN 55013 (1990)
EN 55020 (1991)

Supplementary Information:

The product herewith complies with the requirements of the Low Voltage
Directive 73/23/EEC and the EMC Directive 89/336/EEC as amended by
Directive 93/68/EEC.

Vice-President of Engineering        
8760 S. Sandy Parkway

Sandy, Utah 84070, USA

Date: July 1, 2003

European Contact:

Your local dbx Sales and Service Office
or

Harman Music Group
8760 South Sandy Parkway
Sandy, Utah  

84070  USA

Ph: (801) 566-8800
Fax: (801) 568-7583