dbx DriveRack PA2, Owner'S Manual

U.K. MAINS PLUG WARNING

A molded mains plug that has been cut off from the cord is 
unsafe. Discard the mains plug at a suitable disposal facility.

NEVER UNDER ANY CIRCUMSTANCES SHOULD 
YOU INSERT A DAMAGED OR CUT MAINS PLUG 
INTO A 13 AMP POWER SOCKET.

Do not use the mains plug without the fuse cover in place.  
Replacement fuse covers can be obtained from your local 
retailer.  Replacement fuses are 13 amps and MUST be ASTA 
approved to BS1362.

If you want to dispose this product, do not mix it with general household waste.  There is a 
separate  collection  system  for  used  electronic  products  in  accordance  with  legislation  that 
requires proper treatment, recovery and recycling.

Private households in the 25 member states of the EU, in Switzerland and Norway may return their used 
electronic products free of charge to designated collection facilities or to a retailer (if you purchase a similar 
new one).
For Countries not mentioned above, please contact your local authorities for a correct method of disposal.
By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and 
recycling and thus prevent potential negative effects on the environment and human health.

The symbols shown above are internationally accepted symbols that warn 
of potential hazards with electrical products. The lightning flash with 
arrowpoint in an equilateral triangle means that there are dangerous 
voltages present within the unit. The exclamation point in an equilateral 
triangle indicates that it is necessary for the user to refer to the owner’s 
manual.

These symbols warn that there are no user serviceable parts inside the 
unit. Do not open the unit. Do not attempt to service the unit yourself. 
Refer all servicing to qualified personnel. Opening the chassis for any 
reason will void the manufacturer’s warranty. Do not get the unit wet. If 
liquid is spilled on the unit, shut it off immediately and take it to a dealer 
for service.  Disconnect the unit during storms to prevent damage.

The following is indicative of low 
altitude use; do not use this product 
above 2000m.

WARNING FOR YOUR PROTECTION

READ THE FOLLOWING:

KEEP THESE INSTRUCTIONS

HEED ALL WARNINGS

FOLLOW ALL INSTRUCTIONS

The apparatus shall  not be exposed to dripping or splashing liquid and no object filled with liquid, 
such as vases, shall be placed on the apparatus.

CLEAN ONLY WITH A DRY CLOTH.

FOR INDOOR USE ONLY.

DO NOT BLOCK ANY OF THE VENTILATION OPENINGS. INSTALL IN ACCORDANCE WITH THE MANU-
FACTURER’S INSTRUCTIONS.

DO NOT INSTALL NEAR ANY HEAT SOURCES SUCH AS RADIATORS, HEAT REGISTERS, STOVES, OR 
OTHER APPARATUS (INCLUDING AMPLIFIERS) THAT PRODUCE HEAT.

ONLY USE ATTACHMENTS/ACCESSORIES SPECIFIED BY THE MANUFACTURER.

UNPLUG THIS APPARATUS DURING LIGHTNING STORMS OR WHEN UNUSED FOR LONG PERIODS 
OF TIME.

Do not defeat the safety purpose of the polarized or grounding-type plug.  A polarized plug has two 
blades with one wider than the other.  A grounding type plug has two blades and a third grounding 
prong.  The wide blade or third prong are provided for your safety.  If the provided plug does not fit 
your outlet, consult an electrician for replacement of the obsolete outlet.

Protect the power cord from being walked on or pinched particularly at plugs, convenience recep-
tacles, and the point where they exit from the apparatus.

Use only with the cart stand, tripod bracket, or table specified by the manufacture, or sold with 
the apparatus.  When a cart is used, use caution when moving the cart/apparatus combination to 
avoid injury from tip-over.

Refer all servicing to qualified service personnel.  Servicing is required when the apparatus has 
been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled 
or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does 
not operate normally, or has been dropped.

POWER ON/OFF SWITCH: The Power switch used in this piece of equipment DOES NOT break the 
connection from the mains.

MAINS DISCONNECT:  The plug shall remain readily operable.  For rack-mount or installation where 
plug is not accessible, an all-pole mains switch with a contact separation of at least 3 mm in each 
pole shall be incorporated into the electrical installation of the rack or building.

If connected to 240V supply, a suitable CSA/UL certified power cord shall be used for this supply.

This Equipment is intended for rack mount use only.

IMPORTANT SAFETY INSTRUCTIONS