23
®
further information on the available AFS TYPE options.
8�
Go to the FIXED FILTERS parameter and set it to 12.
9�
Ensure no sound is present at any of the microphones then slowly raise the main mixer faders until you reach your target
gain (described in step 1) or run out of Fixed filters, whichever happens first, then lower the main mixer faders back to
performance level (the level at which you had the mixer’s main faders during sound check in step 1).
10�
Lower the FIXED FILTERS setting to change all unset Fixed filters to Live filters.
11�
Set the AFS MODE to LIVE.
12�
Go to the TYPE parameter and select the desired width for the Live filters – select the MUSIC/SPEECH option for the
best all around real-time feedback protection. See
‘Advanced Feedback Suppression (AFS)’ on page 31
for
further information on the available AFS TYPE options.
13�
The system is now ready for use and any available Live filters will be available for on-the-fly feedback suppression during
the performance.
Note:
When ringing out the system in Fixed mode, any sound detected by AFS will trigger filters to be set. Therefore,
make sure the microphones are active, but there is no signal present at the mics when AFS is active in Fixed mode.
Summary of Contents for DriveRack PA2
Page 1: ...Owner s Manual...
