Etherpoll User’s Guide
42
•
Remote Device
Listen Port is the UDP port number with
which this EtherPoll will communicate.
•
IP Fragmentation
may be disallowed based upon this
configuration.
Data - EtherPoll
IP Address: The IP address of this EtherPoll device on your
LAN in dotted decimal format. The default IP
Address is 192.168.1.1
Note:
If you change the IP Address, the
connection will be lost when you "Save". You
must reconnect using the new IP Address.
Network
Mask:
The network mask indicates what class of
TCP/IP network you have. The default value
(255.255.255.0) is for a class "C" network, with
up to 255 users. This value should work in small
networks. If in doubt, consult your network
administrator.
Gateway IP
Address:
If your LAN contains a router, enter the IP
Address of the Router. Otherwise, leave this
value at 0.0.0.0
Data - Administrator Access Rights
Manager IP
Address
[1] to [4]
Enter the IP Addresses of the PCs which you
wish to have access to the EtherPoll
configuration data. If these are left blank
(default) then all PCs have access.
Data - Remote Device
Summary of Contents for EtherPoll
