10
Home
Display
The HOME display is the SRX default display. It shows the product
name and the number of ports. Pressing the Arrow key will display
firmware version information. Press Arrow again to return to the home
display.
MAP
Host Port
The MAP Host Port screen shows the mapping between the local port
numbers and remote port numbers. As each local port is selected, the
corresponding remote drop and port numbers are listed on the lower
line. If the port is not mapped, dashes (--) will be displayed.
Instructions for changing settings are contained in Section 4.1.3.
Configure
Port Parameters
The CFG screen selects the port configuration parameters for either
local or remote ports one port at a time. Both local and remote
configurations are referenced to the local (host) port number.
Configurable parameters include port loopback (LP/OFF), flow control
and speed.
Configure All
Port Parameters
The CFG All screen selects the port configuration parameters for all
local or remote ports. Configurable parameters include port loopback,
flow control and speed. The default parameters are; loop off, flow control
Xon/Xoff, Space parity and 9600 bps.
Test
Message
The TEST Msg screen transmits a Quick Brown Fox (QBF) message to
any local or remote port. All port numbers refer to local (host) ports.
Once the desired port is selected, the OK! key starts the test. A 15
minute timer begins on the far right side of the display. The test
continues until any front panel key is pressed or for 15 minutes,
whichever happens first.
Network
Activity
The NETwork activity display shows the number of data blocks sent
and received for all drops. The INCR key toggles this display between
the block count and the error count.
