ASSEMBLING THE PASTA MAKER HOUSING
1. Hold the Kneading Paddle(D)at a downward angle and place it into the Mixing Chamber.
2. Slide the Mixing Chamber(B)into place on the Base Unit(A)while inserting the metal end of the
Kneadingpaddle into Base Unit’s receptacle.
3. Insert the Auger(F)into the Auger Sleeve(E). Slide the assembled Auger and Sleeve through
the Mixing Chamber’s mouth so that the Auger shaft fits into the opening of the kneading paddle.
4. Place your selected Pasta Disc(G)on the front tip of the Auger.
5. Place the Extrusion Collector Ring(H)on the front of the appliance. NOTE: The Extrusion Ring
shaft fits through the front slot of the Mixing Chamber.
6. Place the Screw Cap(1)on the front of the appliance and hand tighten until all parts are secure
7. Place the Mixing Chamber Lid(C)on top and snap in place. CAUTION: Operating this appliance
with misaligned or missing parts will cause damage to the appliance.
8.To remove the Mixing Chamber Lid, pinch the lid’s latch and the ridge area to unlock the lid from
the Mixing Chamber.
PASTA MAKER PARTS
A Basic Unit Housing F Auger
B Mixing Chamber G Pasta Disc
C Mixing Chamber Lid H Extrusion
D Kneading Paddle I Screw Cap
NOTE: All pasta parts are marked with a”P”to identify
which attachments are used for pasta making. The
parts of each housing are also color coded to help you
identify which parts are used with which housing
PASTA DISC TYPES (G)
USER MANUAL - MULTI-FUNCTION FOOD PROCESSOR - PM1800
P5= Udon
P6= Angel Hair
P7= Fettuccine
P8 = Lasagna
P1= Penne
P2= Spaghetti
P3= Linguine
P4 = Tagliatelle