ASSEMBLING THE FROZEN TREAT HOUSING
1. Attach the Slow Juicer Housing(U)by pushing it into the matching slots on the Basic Unit
Housing (A). See notes in”Main Unit Housing Backplate”section for assembly.
2. Slide the Auger into the Slow Juicer Housing
3. Slide the Frozen Treat Blocker(X)in place over the Juice/Frozen Treat Auger(V).
4. Attach the Seal Cap (Y) by twisting it until it locks in place. The Seal Cap has an arrow that will
be centered on the housing when the Seal Cap is locked.
5. Place and twist the Star Extrusion Cap (A1) until it locks into place.
6. Place the Pulp Collector on the outside of the Basic Unit Housing (refer to the”Frozen Treat
Mode”section).
FROZEN TREAT PARTS
A Basic Unit Housing
X Frozen Treat
K Chute/Tray Blocker
L Pusher
Y Juice/Frozen Treat
U Juicer Housing Seal Cap
V Juice/Frozen Treat
A1 Extrusion Cap
Star Center*
NOTE: All juicer attachments are marked with a “J”to
identify which parts are used for juicing. The parts of
each housing are also color coded to help you identify
which parts are used with which housing.
*May be sold separately
GENERAL OPERATING INSTRUCTIONS
Before First Use
When making pasta dough in this appliance,the first part of the dough that is extruded from the
appliance might be a little dry. As the dough continues to be mixed, it will become more pliable.
You can cut off and discard the first inch of the dough if desired
When making pasta dough in this appliance, you can experiment with adding different flavors to
your dough. Consult the recipe guide for examples of some of the many different kinds of pasta
doughs you can make in this appliance.
USER MANUAL - MULTI-FUNCTION FOOD PROCESSOR - PM1800