MANUALE D’USO - USER MANUAL - SA9500
dcg16.it
TO TURN ON THE HEATER
1. Ensure the black knob is at the “OFF” position
2. Connect the gas regulator to a compatible gas cylinder
3. Ensure a battery has been inserted into the red ignition button.
4. Push and tum the control knob anticlockwise to the “PILOT” position and hold in for 60 seconds
5. While holding down the black knob, press the igniter button several times until the pilot flame
lights.
6. Once the blue pilot light flame stays alight constantly, release the black knob slowly.
7. Turn the black knob to the desired temperature setting(High/low).
Note:
• If a new tank has just been connected, please allows at least on minute for the air in the gas
pipeline to purge out through the pilot hole.
• When lighting the pilot flame make sure that the variable control knob is continuously pressed
down while pressing the igniter button. Variable control knob can be released after the pilot flame
lights.
• If the pilot flame does not light or it goes out, REPEAT STEP 3.
• A 5 minutes complete shut off period is necessary before relighting.
TO TURN THE HEATER OFF
1. Turn the black knob to the “PILOT” position
2. Push and turn the black knob to “OFF” position
3. Turn off the regulator on the gas cylinder and disconnect.
STORAGE
1. Always close the gas valve of the gas cylinder after use or in case of a disturbance.
2. Remove the pressure controller and the hose.
3. Check the tightness of the gas valve and for damage. If you suspect a damage, have it changed
by your gas dealer.
4. Never store liquid gas cylinder in a sub-terrain, or at places without adequate air ventilation.
CLEANING AND CARE
• Wipe off powder coated surfaces with soft, moist rag. For lacquer surface, use suitable cleaners.
Do not clean heater with cleaners that are combustible or corrosive.
• Remove debris from the burner to keep it clean and safe for use.
