3) Remove Valve Panel (see General instruc-
tions and note removal of "Red" screw behind control
knob)
4) 120 V supplied to Thermostat from the ter-
minal block ?(live= black) If not, troubleshoot power
supply lines, If YES,
5) Disconnect power, Remove live supply wire
from Thermostat & check for continuity between the
live Thermostat terminal and the Bake output terminal
when Thermostat dial is rotated to the "Bake" posi-
tion. If there is no continuity remove / replace
Thermostat.
6) If Thermostat is OK, Remove the wires
from the Bake side of the Thermal Valve and check for
continuity between the two (2) terminals on the face of
the valve. If none, remove / replace.
[Access the Dual
Thermal Valve by removing the top, central section of the cooktop
(may be a Grill, Griddle, or Open Top Burner section, depend-
ing on the model) Next, remove the service access panel in the
rear to expose the Thermal Valve]
7) If the Thermal Valve is OK, Remove the
wires from the Oven Burner Igniter and check the
igniter leads for continuity. If none, remove / replace
igniter.
8) If the Igniter is OK, Check the Live (black)
and Neutral (white) Return Wire for continuity to the
neutral (white) wire of the power supply cord. If Oven
continues to not function, check all related wires for
continuity. -
(refer to the schematic)
1) Verify Gas supply to the unit. Turn the Gas
supply OFF. Loosen tubing supplying gas from the
manifold to the Dual Thermal Valve at the Thermal
Valve. Quickly turn manual valve On, then Off while
an assistant listens closely for the sound of flowing gas
at the loosened end of the connections.
L A RGE OV E N / B RO I L E R T RO U B L E S H O OT I N G
W H A T T O D O :
U S E F U L N OT E S :
P ROBLEM AREA:
(cont'd)
Oven will not
operate
Oven / or Broiler still
will not operate,
(Electrically opera-
tional - Steps 1-8 OK)
N OTE: -Ensure at
the supply source
that the live and
neutral wires are not
reversed
( If they are, this
would not be covered
under warranty)
24