BACKGUARD KITS:
The backguard is located as shown in Fig. 12.
Secure the backguard to the wall behind the
range. Specific instructions for installation of
the full backguard or low backguard can be
found packaged with the backguard. See
also page 5, “Planning The Installation
Section”.A backguard must be installed when
there is less than a 12” clearance between
combustibles and the back of the range
(above the cooking surface) see fig. 11.
STEP 5:
ELECTRICAL CONNECTIONS
Power Requirements Range:
120 VAC, 60 Hz., single phase
RGS-305: 4 Amp. Max.
RGS-36: 7 Amp. Max.
RGS-48: 13 Amp. Max.
(use 15 Amp. circuit)
Always disconnect electric supply cord from the
wall outlet or service disconnect before servicing
this appliance. Observe all governing codes and
ordinances when grounding, in absence of
which, observe National Electrical Code
ANSI / NFPA No. 70-1990.
RECOMMENDED GROUNDING METHOD
This appliance is factory equipped with a power
supply cord with a three-prong grounding plug (with polarized parallel blades). It must be plugged
into a mating grounding, type receptacle, connected to a correctly polarized 120 volt circuit. If the
circuit does not have a grounding type receptacle, it is the responsibility and obligation of the installer
to have the existing receptacle changed to a properly grounded and polarized receptacle in
accordance with all applicable local codes and ordinances by a qualified electrician. In the absence of
local codes and ordinances, the receptacle replacement shall be in accordance with the National
Electrical Code.
The third prong should not, under ANY circumstances, be cut or removed.
ELECTRICAL / GAS CONNECTIONS
BACKGUARD INSTALLATION
13
Fig. 12
Wall Mount
Full Backguard
(Model #’s BGS-3030,
BGS-3036, BGS-3048)
Wall Mount
Low Backguard
(Model #’s BGS-1230,
BGS-1236, BGS-1248)
Receptacle Box
Cover Plate
Three Prong
Receptacle
Three
Prong
Plug
Fig. 13
Receptacle Box
Cover Plate
Three Prong
Plug
Three Prong
Receptacle
Summary of Contents for RGS-305
