UNPACKING AND HANDLING
7
After checking the countertops for level and
before sliding the range into place, measure the
distance from the floor to the top of the counter
work surface in the rear left and right corners.
Adjust the corresponding rear corner of the range
to an equal height of the counter, as the rear
leveling legs are not accessible once the range is
pushed into place. Once the range is in place, the
front leg levelers can be accessed to level the
front of the range. Replace the kick panel and
oven doors by reversing the procedure described
previously. It is important that the two screws
retaining the kick panel are secure to prevent
accidental access to live electrical components
and wires (fig. 1 pg. 5).
GRIDDLE AND GRILL LEVEL ADJUSTMENTS
The grill and griddle sections (if equipped) are
fastened in place at the front with screws. They
are designed to be stationary and not meant to
be removed for cleaning. The griddle has two
leveling screws beneath the rear flue cover which
can be used to adjust the griddle to the desired
slope. To access the leveling adjustment screws,
remove the griddle flue cover by lifting upwards.
The center screw is for shipping and should be
removed.
DOOR HINGE ROLLER
LOCK
(CLOSE)
UN-LOCK
Fig. 4
Fig. 5
Shipping Screw
(remove)
Outer Leveling
Screws (2)
Griddle Flue
Cover
Door Hinge Roller
Lock
(close)
UnLock
Summary of Contents for RGS-305
