Novamid ID1030-CF10 (Nylon (PA6/66) + carbonfiber)
Use the following configuration:
1.
Clean tungsten-carbide 0.4 nozzle (dddrop’s special);
2.
Original spring for extruder;
3.
Filamentreel of DSM Novamid ID1030-CF;
4.
FFF profile Novamid ID1030-CF (
https://www.dddrop.com/dddrop-support/
5.
Magigoo PA (instruction of use is inside the Magigoo package).
(
https://www.dddrop.com/products/parts/
6.
Set the Novamid ID1030 CF10 filament as shown in picture “Set filament in Filament
Management Module”.
Important notes:
1.
All kind of Nylon are sensitive to moisture. It has to be dried for good 3D print results.
6-8 hours on 70-90 degrees. Use the PrintDry filament dryer or an air-circulated
oven.
2.
Keep the cover of the dddrop 3D printer always closed while printing a product.
Don’t open the cover for any reason. This will cause bigger warping problems.
3.
Tested with products with dimensions of 50 x 50 x 50 mm.
4.
PA (Nylon) is a material which warps a lot. The amount of warping depends on the
type of product you print. Massive products will warp more than thin products.
