© DDO2018
3
Footrests can be easily removed and safely secured to the frame, using the footrest locking
mechanism
Foot plates flip‐up easily
Side guards slide in and out easily
Brakes are assembled, adjusted and operate correctly
Seat fasteners are fully tight and seat strap is firmly fastened
Cushion size and orientation is correct
Backrest adjustment bolts are fully tight
Backrest straps are firmly fastened together
All straps are correctly located
All fasteners are tight.
Note:
Do not over‐tighten the nuts and bolts.
Transport
Remove the quick‐release rear wheels before transporting
Remove the cushion
Remove the footrests, if needed
Remove the side guards, if needed
Fold the frame
Lift the wheelchair up by the frame. Do not lift the wheelchair by the upholstery.
Before use, replace all the parts that have been removed
Note
: Check that the rear wheel axles are clean before inserting into the frame, as dirt may get stuck on
to the axles. Before use check that the rear wheel axles are securely locked to the frame.
Ongoing
Keep the wheelchair clean and dry
Do not leave the product outside, exposed to elements, as this will damage the product and
shorten the product lifespan.
If any part of the product stops functioning properly, please consult a trained wheelchair
technician of your local service provider.
HANDLING YOUR WHEELCHAIR
Folding the wheelchair
Folding
Remove the cushion
Fold the wheelchair frame by pulling up on the seat panel
Unfolding
Unfold the frame by pushing down on the seat panel and the seat
tubes
Check that the seat tubes are correctly seated in the seat tube cups
Place the cushion on the seat panel
Note:
Please pay attention at the cushion orientation relative to the seat
panel
Removing/ placing the footrests
