22
De Gier B.V., Westlandseweg 9, 2291 PG WATERINGEN, THE NETHERLANDS,
+31 (0)174 292089, sales@degierdrivesystems.com, www.degierdrivesystems.com
Versie 1 – 2020 / 03 / 01
Parts may only be replaced by qualified staff. Only use original spare parts and original lubricants. For product safety
reasons, De Gier B.V. will supply only complete motor gearboxes, limit switches and potentiometers as replacement parts.
Gear unit parts may only be replaced or repaired by an authorised service provider of De Gier B.V.
11. Disposal
Caution!
Improper disposal of waste oil is a hazard to the health and the environment. Used oil must be taken to a collection
point for waste oil. Avoid prolonged skin contact.
Drain used oil from the motor gearbox. The used oil must be collected, temporarily stored, transported and replaced
professionally. Observe national legislation.
Collect waste oil and remove it in accordance with the regulations. Remove any spilled oil immediately using a suitable
emulsifier or absorbent material.
Dispose of the gears, shafts and rolling bearings of the motor gearbox as steel scrap. This also applies to the stain-
less-steel cover plates unless there are provisions for separate collection. The worm wheels are partly made of heavy
non-ferro-metal alloys. The lightweight metal gearbox housing is made of aluminium. Dispose of these accordingly.
Dispose of the packaging material in accordance with the regulations or take it to a recycling point.
Motor gearbox parts
Material
Gear wheels, shafts, bearings, retaining rings
Steel
Cover plates
Stainless steel
Gearbox housing
Aluminium
Worm gears
Bronze
Shaft seals, sealing caps
Elastomer (with steel)
Flat gaskets
Elastomer, asbestos-free sealing material
Gear oil
Enriched mineral oil
12. Warranty
We only provide warranty on original parts supplied by us. The warranty period and -terms can be found in the
“Terms and Conditions of the Metaalunie” . On request a copy of these terms can be sent to you free of charge. For
the Blue-line range a warranty period of 3 years is applicable.
Subject to modifications.
10. Replacing and removing parts
