Programming the master combination
Monitoring the batterycharge level,
replacing the batteries
Programming the electronic lock
If the charge remaining in the batteries is insufficient, then
the red and green LEDs will blink alternately 10 times after
the combination has been entered. This is to remind you to
install two new 1.5 Volt AA (alkaline) cells in the next few
days.
Note
: If you ignore the low
-
battery warning over a longer
period of time, then you must be aware of the hazard that it
will be possible to open the lock and, as a consequence, the
safe only after new batteries have been installed. The battery
compartment cover is located to the right of the keypad
housing. Remove the Phillips screw and then slide the battery
compartment cover carefully off of the keypad housing in the
direction indicated by the arrow. See Figure 1. Remove the
exhausted batteries and replace them with two new 1.5 volt
AA (alkaline) batteries. The direction in which the batteries
are to be installed is shown inside the battery compartment
cover. The programmed combination will be retained during
battery replacement.
Note
: Program only with the door open and the electronic lock released. The green LED must not be lit
Before you use your safe for the first time it is necessary, for
security reasons, to enter your personal combination; the
factory combination must not be retained. The lock should be
programmed only with the door open and with the electronic
lock released. Select your new six
-
digit combination before
starting the easy programming sequence. Do not use any
personal data for this combination, such as birthdays or other
information which could be derived from knowledge about your
person. Store your combination in a safe place so that only you
have access to it.
Note:
We can assume no guarantee liability for malfunctions caused by erroneous reprogramming or application of undue force or im-
proper treatment nor in case of injury to property or assets which, for example, is due to a failure to close the safe properly. We recom-
mend obtaining suitable insurance coverage to protect the contents of your safe. Your property insurance sales agent can provide de-
tails.
Troubleshooting in case of malfunction
If it is not possible to open your safe in spite of having carried out the instructions above, then please contact the safe
manufacturer.
