Dea 602AN, Operating Instructions And Warnings

9

2  PRODUCT DESCRIPTION

Models and contents of the package

OLI 600 identi

fi

 es a series of hydraulic gate operators with different features in terms of dimension (stroke), speed, reversibility, and 

blocks.
OLI is a hydraulic operator for civil and industrial swing gates. It consists of a pump in an oil bath, powered by a single-phase electric 
motor that drives a cylinder.
OLI 600 is completed by a set of accessories listed in the “PRODUCT ACCESSORIES” table (page 55).
Inspect the “Contents of the Package” (Pic. 1) and compare it with your product for useful consultation during assembly.

Transport

OLI is always delivered packed in boxes that provide adequate protection to the product, however, pay attention to all information that 

may be provided on the same box for storage and handling.

3  TECHNICAL DATA

602N (602AN) - 

603N - 604N

605N - 606N 

(607AN)

602LN (602LAN) - 

603LN - 604LN

605LN - 606LN 

(607LAN)

Motor power supply voltage (V)

230 V ~ ±10% (50/60 Hz)

Absorbed power (W)

170

Thrust force (N)

3980

5600

Traction force (N)

3200

4460

Duty cycle (cycles/hour)

60

50

40

Maximum n° of operations in 24 hour

480

400

320

Built-in capacitor (

μ

F)

8

Operating temperature range (°C)

-20÷50 °C

Motor thermal protection (°C)

130

Opening time 90° (s)

21

31

30

40

Weight of product with package (kg)

11,4

13

11,4

13

Sound pressure emitted (dBA)

< 70

Type of oil used

AGIP Arnica A15 

Protection degree

IP55

4  INSTALLATION AND ASSEMBLY

4.1 For a satisfactory installation of the product is important to:

•  Verify that the gate complies with the legal requirements and then de

fi

 ne the complete project of the installation;

•  Verify that the gate is well balanced and that it has no points of friction in opening and closing;
•  Identify an area that allows a smooth and safe manual operation of the operator;
•  Verify that the operator bulk (Pic. 2) is compatible with the area chosen for the 

fi

 tting (Pic. 3);

•  Use the length/weight graphic and the provided installations dimensions evaluating whether you prefer a 90° or higher opening (Pic. 

4).

4.2 De

fi

 ned and satis

fi

 ed these prerequisites, proceed to the assembly:

•  Fix the rear junction to the pillar bu welding (Pic. 5);
•  Fix the front junction to the gate by welding (Pic. 6);
•  Keeping the motor in a horizontal position, mount it 

fi

 rst to the front bracket, then to the rear bracket (Pic. 7) ensuring that installation 

dimensions shown in Picture 4 are respected.

• 

To prevent excessive pressure from forming inside the hydraulic cylinder, before carrying out opening/closing manoeuvres, 
open the protective cover of the release system and loosen the screw on the handle by 1 turn (Pic. 8).

WARNING

 In order to make the structure suf

fi

 ciently strong, reinforcement plates to be 

fi

 xed to attachments may be necessary.

WARNING

 Grease pins before assembly.