2.1 Print Engine Control
4.
During print mode, the fusing temperature is maintained, interlocks are
tested, and printing is performed.
5.
During the last rotation mode (LSTR) the last page of the job is ejected
and the transfer roller is cleaned. If a
P RNT
signal is received during this
mode, then initial rotation mode immediately begins.
Figure 2–3 Print Engine Modes Timing Diagram
WAIT
STBY
INTR
LSTR
STBY
Transfer ± charges
Develop DC charge
Develop AC charge
Primary DC charge
Primary AC charge
Scanner motor
Main motor
VSYNC (Vertical SYNC signal)
PRINT (signal)
Fusing heater
READY/WAIT indicator
Flashing
Steady glow
162ºC
172ºC
183ºC
172ºC
0.2
0.3
0.3
0.73
0.51
0.65
Between the pages bias
Print bias
Power On
Negative bias
About 4
0.88
1.1
1.71
About 1
About 1
DSG-000595
Technical Description 2–7
Summary of Contents for DEClaser 5100
