Footplate height is adjusted by varying the posi ons of the "F5" screws in rela on to the support plates, as
follows:
●
Unscrew and remove the 6 "F5" screws between the plates and blocks "EE" and "FF".
●
Align the holes to obtain the desired posi on.
●
Re-insert and properly ghten the "F5" screws.
The angle can be varied by fi ng the "F5" screws at different heights to the front and rear plates.Depth is
adjusted by varying the posi on of the "EE" and "FF" blocks in rela on to the frame or the pla orm in rela on
to the "CC" blocks.Changing the posi on of blocks "EE" and "FF" is easier and allows for more posi on
possibili es. To change the posi on of the "EE" and "FF" blocks:
●
Loosen the "F6" screws without removing them
●
Choose the desired posi on
●
Tighten the "F6" screws firmly
To change the posi on of the footplate in rela on to the "CC" blocks:
●
Unscrew and remove the “F7” screws.
●
Align the holes to obtain the desired pla orm posi on.
●
Re-insert and properly ghten the "F7" screws.
4.10 Adjus ng the an - lt wheel
To adjust the depth of the wheel:
●
Unlock the "K" collar by pulling the lever
●
Increase or decrease the depth of the wheel to suit your requirements
●
Tighten the "K" collar
●
If the collar is too ght, turn the handle counterclockwise several mes, if it is too loose, turn it
clockwise un l you get the right tension
To adjust the height of the wheel:
●
Loosen but do not remove the "AH" screw which determines the an - lt wheel's height rela ve to the
ground.
●
Raise or lower the wheel as desired.
●
Tighten the "AH" screw firmly.
4.11 Adjus ng the thigh a achment strap
Prepara on
The thigh a achment strap is made up of:
●
A padded strap (A) with 2 buckles (B),
●
A mobile buckle (C),
●
An a achment strap (D).
14
Summary of Contents for TW500
Page 182: ...181 ...
