GENESIS-II DIRECTIONAL
™
USER’S AND INSTALLATION MANUAL
19
Rev. 02/05
3. Operating the Genesis-II Directional
After you test and confirm that the unit is properly installed,
it is ready for use.
3.1 Power
The
PWR
button on the hand-held remote turns the
Genesis-II Directional
on and off. After you press the
PWR
button, the display illuminates and the computer
checks the circuitry. If the power-up checks pass, the
computer displays
TEST PASS
in the
MODE
window. If
the power-up checks fail, a system error message
(SYS)
will display in the
MODE
window and the unit will not
respond to any control except the
PWR
button to power
down. Turn the unit off then back on. If the error
message persists, remove the unit from service and
contact the Decatur Electronics Repair Department.
When the Genesis-II Directional is powered down, it stores
the current settings. These settings are restored the next time
you power up the unit.
Summary of Contents for GENESIS-II DIRECTIONAL
