GENESIS-II DIRECTIONAL
™
USER’S AND INSTALLATION MANUAL
21
Rev. 02/05
The
Genesis-II Directional
has three main operating
modes: Stationary, Moving Mode Opposite Direction,
and Moving Mode Same Direction.
3.3 Stationary Mode
You can use Stationary Mode to monitor traffic that is
moving toward or away from the parked patrol vehicle.
You can also select a specific direction of traffic
(towards or away) to monitor.
Figure 3.3a Tracking a vehicle moving AWAY from a stationary patrol
car using the FRONT antenna.
There are three selections for stationary mode;
Stationary Both
(Tracks vehicles moving towards
or away from the patrol vehicle)
Stationary Towards
(Only tracks vehicles coming
towards the patrol vehicle)
Stationary Away
(Only tracks vehicles moving
away from the patrol vehicle)
To select a Stationary Mode of operation, press and hold
the MODE button for two seconds. The “Stationary
Both” mode will be represented by two arrows on the
left (one pointing up, one pointing down) and a solid line
on the right representing a parked patrol car. When
targets are measured, the letter “T” or “A” will be
displayed along side of the solid line to indicate the
target is moving TOWARDS or AWAY from the patrol car.
Summary of Contents for GENESIS-II DIRECTIONAL
