GENESIS-II DIRECTIONAL
™
USER’S AND INSTALLATION MANUAL
22
Rev. 02/05
Figure 3.3b Stationary Both Mode
In order to select the “Stationary Towards” or “Stationary
Away” modes, one of the antennas must be activated.
Detected target speeds will display in the
TARGET
window. The
PATROL
window will always remain
blank while in this mode.
After the “Stationary Both” mode has been selected,
briefly press and release the MODE button a second
time to select the “Stationary Towards” mode.
Pressing and releasing the MODE button a third
time will select the “Stationary Away” mode.
Pressing and releasing the MODE button a fourth
time will cycle to the moving opposite mode of
operation.
When the radar is toggled into the “Stationary
Towards” mode, a “T” will briefly be displayed along
side of the solid line on the right. When the “T’ is
cleared, an arrow will be displayed that represents
the direction of travel in which the radar will search.
(When using the FRONT antenna, targets moving
towards the patrol will be represented by an arrow
on the left pointing down. An arrow will be pointing
up when the REAR antenna is selected.) Once a
solid target is acquired, the letter “T” will again
appear.
Summary of Contents for GENESIS-II DIRECTIONAL
