Sp
eedSp
y™
U
ser
’s & I
nstalla
tion M
anual
8
Figure 2.2c
SpeedSpy Lock
Figure 2.2b
SpeedSpy Mount
4 . Unlatch the enclosure door and open . Insert one of the two
12 VDC lead sealed batteries . (See Section 3 .1-
Removing and
Attaching the Battery
for details .)
5 . Insert the EZ Stat™ module into the male 9-pin connector .
Reference the red locator label on the enclosure door .
6 . Turn on the unit . The power switch is located inside the box .
The unit will operate for approximately two days before the
battery must be recharged . Close and lock the case . The unit is
waterproof only when the case is sealed . Failure to seal the case
may lead to permanent damage to the radar unit .
7 . The EZ Stat™ will collect speed data events . The EZ Stat™ reads
vehicle speeds 5 times per second . When a moving object is
detected by the radar, the logger expects it to be present for
at least 4 seconds, then receive a zero speed . The maximum
speed will be recorded with the timestamp in the memory of the
logger module .
NOTE: The EZ Stat™ will not create a record if another car is in range
of the radar before the first one passes beyond the antenna . When
traffic is heavy, there will be no gap (zero speed) in speed readings,
and the EZ Stat™ will see the whole cluster of cars as one event .
