8
Using the Application with the Appliance
It is highly recommended that the user places their iDevice
into “airplane mode” prior to using the Cue Command
applica on. Airplane mode turns o
ff
the various radios
on the device and therefore prevents interrup ons from
messages or phone calls.
Prior to the
fi
rst use, it is necessary to download and install
the free Cue Command applica on from the iTunes app
store. This can be done through the iTunes app on a Mac
or PC or in many situa ons, from the iDevice itself so long
as it’s connected to a network. In all cases, search the App
Store for “Cue Command”. It is also necessary to have at
least one PlayList on your device. Instruc ons for crea ng
a PlayList can be found in iTunes.
Once your Appliance and Transmi er have been
con
fi
gured as previously described, you are ready to begin
using your new device with the Cue Command Applica on.
Connect power, the antenna and a 3.5mm (standard 1/8”)
audio cable from the Cue Command’s audio port (blue
connector on back of unit) to headphones, an ampli
fi
er,
mixer or powered speakers. Unlock your iDevice by using
the slider (and password if required) and then plug it into
the Apple (newer Lightning or older 30-pin) cable. Use a
Lightning to 30-pin adapter (available directly from Apple)
if needed. The applica on will not launch if the device is
locked when connected to the appliance. Take care to set
your ampli
fi
er at a rela vely low volume level un l you
