3
2. A er a few seconds, release the bu on and
the randomized address will be saved. The LED
will begin
fl
ashing to indicate that the Control
Permissions may now be set.
3. Press each of the
fi
ve bu ons on the transmi er.
It does not ma er in what order the bu ons are
pressed, only that each bu on is pressed at least
one me. If a bu on is not pressed during this
learning phase, that bu on will not transmit during
use.
4. Press the CREATE bu on again with the paperclip
or wait seventeen (17) seconds for it to me out.
The address and Control Permissions are now set
.
Once the address and Control Permissions are set, the
transmi er is now programmed and you are ready to
customize the receiver in the dock.
Special note:
Some users have found it bene
fi
cial to deliberately omit
certain bu ons (step 3 above) from the programming
sequence. For example, let’s say you had an assistant in
the audience who was there to adjust the volume level and
you did not want them to have control over other aspects
of your music. Selec ng the volume up and down bu ons
during the programming sequence would give them
volume control but they could not start, stop or fade-out
the music.
