Determining Wall Channel Location
94
2
-
957
mm
(Wall to outside of wall channel)
94
2
-
957
mm
(W
all to outside of wall channel)
4
When commencing step 1 on the following page, please refer to this drawing and the instructions below
to assist in the correct location of the wall channels.
SHOWER
WALL
SHOWER
DOOR (MAY
HINGE FROM
OTHER SIDE)
- Measure for the location of the outside edge of the wall channel from the inside of the shower wall.
If a shower base is fitted, do not measure from the edge of the shower base to determine the position
of the wall channel.
- If your wall and shower base are not at right angles the glass will not push fully into the wall channel
at the top or bottom. This misalignment is acceptable if not exceeding 15mm, however the overall
shower size will then increase by the amount of this misalignment.
- If the screen footprint does not turn out square while the aluminium braces are being installed (step
3), the glass can be pulled out from the full depth of the channel by up to 15mm to assist in squaring.
