Network Information
For X.25 line connection
If the PU was assigned an X.25 line type in the Controller Configuration PU Selection menu,
then the following parameter will appear on the Network Information menu screen.
Connection Number
If you intend to initiate SVC calls from the controller or want
to verify incoming SVC calls using a network address, an
entry is required here. For X.25 - The Network Address of
the AS/400 System. Up to 15 numeric characters (0-9).
For Token Ring line connection
If the PU was assigned a Token Ring line type in the Controller Configuration PU Selection
menu, then the following parameter will appear on the Network Information menu screen.
SAP
Enter the Service Access Point (SAP) for the controller. The
value is in hexadecimal ranging from x'04' to x ‘FC', in
multiples of 04. For example, valid values could be x'04',
x'08', x'0C', x'10', and so on.
For Ethernet Attachment
If the PU was assigned an Ethernet attachment, type in the Controller Configuration PU
Selection menu, then the following parameter will appear on the Network Information menu
screen.
SAP
Enter the Service Access Point (SAP) for the controller. The
value is in hexadecimal ranging from x'04' to x ‘FC', in
multiples of 04. For example, valid values could be x'04',
x'08', x'0C', x'10', and so on.
NOTE:
Each Ethernet adapter has a unique MAC address.
Since each Ethernet adapter is capable of supporting
several PU’s and a Gateway, they must be differentiated by
using the SAP address.
The currently defined SAP addresses are displayed on the
screen. Use other addresses.
4
Summary of Contents for 3000 Series
Page 1: ...Series 3000 STK3494 3494 User s Manual ...
Page 2: ......
