INSTALLATION INSTRUCTIONS • EOVATIONS
EOVATIONS INSTALLATION INSTRUCTIONS 11
8529
EOVATIONS INSTALLATION INSTRUCTIONS, CONTINUED
Stair installation
©2020 UFP Retail, LLC. Deckorators is a registered trademark of UFP Industries, LLC. in the U.S. All rights reserved.
5 Meadowcraft Parkway, Selma, AL 36701 800.332.5724 8529_4/20
Deckorators.com
• Stairs must be constructed according to national and local building
codes. Generally, building codes require 3' minimum wide treads and
11" minimum tread depth.
• 9" maximum center-to-center spacing of stringers is required.
• Stair treads should be fastened over a minimum of 5 stringers to
meet code requirements.
• 1/2" maximum tread overhang over stringers.
• 1/8" minimum gap between stair-tread boards. Local building codes
may require the gap to be increased to 1/4" - 3/8" in order to maintain
the minimum tread depth.
Like most composites, Deckorators Decking will have color variations
from piece to piece. This is due to naturally occurring variations in
polymers. Purchasing all required decking material at one time is
recommended, as manufacturing runs can produce slightly different
colors. Do not install if color variation is not acceptable.
Mold and mildew can be a nuisance on any exterior building surface,
regardless of the material. If the conditions are right, they will grow on
wood, plastic, concrete, metal and other surfaces. Mold formation is
most prevalent in consistently wet, shaded areas. Spores from the nat-
ural environment are carried by the wind and commonly land on decks
surfaces. It is important to note that the appearance of mold/
mildew is a function of nature, not necessarily a deficiency with any
of the material on which it grows.
Periodic washing with soap/mild detergent and water will help remove
surface dirt. This will also help prevent the buildup of pollen, debris and
spores that can cause and accelerate mold/mildew growth.
Caution: A pressure washer should not be used to “blast” mold/mildew
or soils from a deck surface. The abrasive nature of the water stream can
potentially cause damage by driving the spores deeper into the material,
which may create a more challenging problem to remedy. A pressure
washer with a fan-tipped nozzle should be used only to lightly wet or
rinse wood or composite deck surfaces.
There are many deck wash and exterior cleaning products available at
retail. It is important to make sure you use a cleaner specifically intended
for your application. After selecting a product, be certain to read,
Stringer
Stair tread
Eotek2.pdf
9" max.
36" min.
5 stringers
required
11" min.
depth
1/8" min.
gap
••
•
•
•
•
•
•
•
THE DIAGRAMS AND INSTRUCTIONS IN THIS BROCHURE ARE FOR ILLUSTRATION PURPOSES ONLY AND ARE NOT MEANT TO REPLACE A LICENSED PROFESSIONAL. ANY CONSTRUCTION OR
USE OF THE PRODUCT MUST BE IN ACCORDANCE WITH ALL LOCAL ZONING AND/OR BUILDING CODES. THE CONSUMER ASSUMES ALL RISKS AND LIABILITY ASSOCIATED WITH THE
CONSTRUCTION OR USE OF THIS PRODUCT. THE CONSUMER OR CONTRACTOR SHOULD TAKE ALL NECESSARY STEPS TO ENSURE THE SAFETY OF EVERYONE INVOLVED IN THE PROJECT,
INCLUDING, BUT NOT LIMITED TO, WEARING THE APPROPRIATE SAFETY EQUIPMENT. UNIVERSAL FOREST PRODUCTS, INC., MAKES NO WARRANTY, EITHER EXPRESS OR IMPLIED,
AND SHALL NOT BE LIABLE FOR ANY DAMAGES, INCLUDING CONSEQUENTIAL DAMAGES.
Color variation
Mold and mildew growth
Cleaning
Mold inhibitors
understand and follow all instructions supplied by the manufacturer.
Some cleaning products and inhibitors may be more effective than
others, depending on the environmental conditions your deck is
subjected to. Additionally, it is always a good idea to test the cleaner
in a small, inconspicuous area prior to applying it to the entire deck
(www.deckorators.com).
Tips for snow removal: Care should be taken when removing snow from
your deck to avoid damaging the deck surface. Use a plastic snow
shovel, one without a metal edge. A stiff push broom can work very well
and minimizes lifting. Light snow can be cleared using a leaf blower. Do
not attempt to break up or scrape ice from the deck surface; use ice
melt products when needed. No concerns have been reported using ice
melt products labeled “Safe for Pets”.
As with deck washes, there are several mold-inhibitor products available
from paint stores, hardware stores, online outlets and home centers to
help prevent long-term mold/mildew growth. For any product selected,
be certain to read, understand and follow all instructions provided by the
manufacturer. Depending upon the environmental factors affecting your
deck, some preventive cleaning products may be more effective than
others. It may be necessary to try more than one product. For ongoing
preventive maintenance, follow the manufacturer’s recommendation.
Note: Deckorators is not suitable for structural use. It should not be
used for primary load-bearing members such as posts, joists, beams or
stringers. The same commonsense precautions should be taken when
handling Deckorators as with wood or other building materials. Dust
masks and eye protection devices are recommended to avoid possible
irritation from sawdust and chips. Gloves will help protect hands.
Hands should be washed after construction work.
