20
Using for the first time
− Stir the material thoroughly and thin it in the paint tub in accord-
ance with the thinning recommendation.
Spray material
Thinning
recommendation
Nozzle
diameter
Glazes, wood preservatives, stains, oils,
disinfectants
Unthinned
(max. 40 DIN-sec)
1.0 mm
Solvent-based or water-soluble lac-
quers, primers, vehicle topcoats, 2-com-
ponent paints, clear lacquers
Thin by 0-10 %
(max. 40 DIN-sec)
1.0 mm
Indoor wall paint
Thin by approx.
5-10%
(max. 100 DIN-sec)
2.5 mm
All other viscous materials
Max. 150 DIN-sec
3.5 mm
1. Use the container (
15
) for the viscosity test in order to check
whether your paint has the required viscosity (see
Fig. C
). Fill the
container for the viscosity test with the required spray material
until completely full.
2. Let the spray material in the container run out through the open-
ing in the bottom and note the time it takes for all the spray ma-
terial to emerge. The time recorded is the basis for calculating the
viscosity of the spray material in the unit DIN-sec.
3. If you are unsure about which material to use for your project, ask
your paint dealer or a similar specialist.
Filling in the material
1. Remove the spraying unit (
9
) ⁄ (
11
) from the motor unit
(
2
) as described in the section “Attaching/replacing the spray-
ing unit”.
2. Open the paint tub (
8
) by unscrewing the lid (
10
) coun-
ter-clockwise (see
Fig. A
).
Layout_DS_FSS_500_EX_UK_SPK7.indd 20
Layout_DS_FSS_500_EX_UK_SPK7.indd 20
19.11.2020 15:15:29
19.11.2020 15:15:29
