24
Operation
Spray pattern of the spraying unit for indoor wall paints
1. Undo the union nut (
4
) a little by turning counter-clockwise.
2. Turn the air cap (
19
) into the required spray pattern position
(see
Fig. G
).
3. Tighten the union nut by turning clockwise, holding the air cap
firmly as you do so.
Controlling the material volume
With the help of the setting screw for controlling the material volume
(
7
) you can set at the trigger (
6
) the supply of the material vol-
ume as required. (see
Fig. D
).
There is also a scale for orientation at the trigger.
− To reduce the material volume, turn the setting screw coun-
ter-clockwise (-).
− To increase the material volume, turn the setting screw clockwise
(+).
Adjusting the spray width
With the help of the lever (
5
) for setting the spray width you can
make the spray cone wider or narrower (see
Fig. D
).
− Push the lever for setting the spray width towards or to position
in order to make the spray cone wider (position = maximum
cone width).
− To make the spray cone narrower, push the lever for setting the
spray width towards or to position (position = minimum cone
width).
Layout_DS_FSS_500_EX_UK_SPK7.indd 24
Layout_DS_FSS_500_EX_UK_SPK7.indd 24
19.11.2020 15:15:29
19.11.2020 15:15:29
