7
®
DO NOT!
install the Denver e-Rib-
bon Fire in a wall construction, which
is open above and below fireplace.
The warm air will cause turbulences
inside this hollow construction, which
will have a negative impact on the
flames.
DO!
install the Denver e-Ribbon Fire
in an open-wall construction, which
is closed above and below the fire-
place. Make sure to create a closed
cavity for the section below and
baseplate of the fire.
DO!
install the Denver e-Ribbon Fire
in a massive wall (made of bricks,
stone or gas beton) using the wall
cut-out dimensions mentiones on the
previous page.
There are various possibilities of installing this fireplace model: resting on top of the surrounding
surface, counter-sunk by means of using a router or the mounting brackets which are included in the
scope of delivery. The scope of delivery contains: the Denver e-Ribbon Fire with its base plate which
is fitted to the tank and electronics of the e-Ribbon Fire, a power cable, one remote control, a manual
with serial number, a funnel, small plastic bags with fitting brackets, and one or more glass screen/s
with glass holders if specified in the technical drawing (figure 1.5),
1
2
3
4
5
®
Figure 1.5
4.2. wALL CONSTRUCTION
4.3. STEP-BY-STEP INSTALLATION PROCESS
