6
Decoflame ApS Danmark. ~ info@decoflame.dk
~ tel. +45 96 3048 00 ~
OPERATING INSTRUCTIONS
decoflame® Denver S
decoflame® Denver F
Your decoflame
®
fireplace with e-Ribbon Fire has a built-in child safety ON/OFF switch which is located
underneath the pop-up lid of the LED-display.
ALWAYS
start operation of your decoflame
®
fireplace using its
built-in automatic by switching it on (push down onto the pop-up lid to the left, flip it over and switch the
ON/OFF button into the ON position) and then start the ignition process by pressing the START button either
on the remote control or on the operating panel next .
DO NOT
use lighters or matches.
ONLY
adults may
operate the electronics of the decoflame
®
e-ribbon Fire.
All decoflame
®
bioethanol fireplaces are designed and manufactured exclusively for use with bioethanol of
highest purity (96%).
DO NOT
use any other fuel or materials or bioethanol of inferior quality as this will void
your warranty. Bioethanol can be bought in specialist shops or on the internet – ask your decoflame
®
point of
sale for advice.
Switching on
Start the electronics of your decoflame
®
e-ribbon Fire by pushing down onto the pop-up lid to the left, flipping
it over and switching the ON/OFF button into the ON position. Flip the lid back so that the LED-display is fully
visible. The first line of the LED-display will show the message READY or FUEL LOW, the second line
indicates the fuel level.
LED-display and Use of Remote Control
The LED-display will always show the following –
Line 1:
Flame level or message (e.g. READY, FLAME 3 or FUEL LOW)
Line 2:
Fuel level indicator bar
During operation of the fire, you could close the pop-up lid of the LED-display completely by pressing down
onto it until you hear a soft “click” sound. You can still use the remote control in order to change the flame
level settings or to shut down the fire, despite the display being invisible.
Filling of the Fuel Tank
– First time fuelling
Switch on the electronics of the fireplace as described above. The display will show the message READY or
FUEL LOW. Push down onto the pop-up lid to the right. Open the fuel tank inlet by pulling the closing
mechanism towards you. Insert a funnel and fill in the bioethanol. Once the fuel tank is filled by three-
quarters, you will hear an acoustic signal. This tone will increase in line with the rising fuel level. Once the
tank is completely filled, a constant tone will sound. Stop the filling process. Avoid spillage during filling. If
you spilled any bioethanol, use a paper kitchen towel in order to wipe off thoroughly any spilled liquid around
the fuel inlet. Remove the funnel. Close the pop-up lid for the tank inlet.
NB: Do not fill the bioethanol tank whilst the electronics of the fireplace are switched off.
NB: The ignition process will not start if any humidity is detected around the fuel inlet or if the pop-
up lid for the tank inlet is left open.
LED-display
base plate
ventilation slots
fuel inlet
housing
flame tray
fuel inlet
LED-display
ventilation slots
power cable
power cable
flame tray
housing
base plate
