80
7
7.2. Anti-tampering Function Setting
By setting the anti-tampering function, you can prevent operation of the wheelchair using the
controller.
(1) Setting
Method
Purpose of Operation
Operation Method
Parameter Status during Operation
and Its Meaning
[1]
[Preparation]
Prepare to set the
anti-tampering function.
Stop the wheelchair in a stable
state, engage the parking brake,
and power OFF.
Off
[2] [Start Operation]
Speed switch
Power switch
1 Turn on the power switch.
2 Lower the speed switch to select
the slowest speed, and then
release your hand from the
switch.
[3]
[Anti-tampering Function
Setting]
Speed switch
Horn switch
1 Hold down the speed switch.
2 Once the buzzer beeps, release
your hand from the switch.
3 Immediately push the horn switch
long.*
4 Confirm that the anti-tampering
function setting is complete on
the LCD and release your finger.
Anti-tampering function setting
screen
* If the buzzer sounds when the horn switch is pushed, the operation was not completed successfully. Hold down
the speed switch again and repeat the procedure.
Note that the anti-tampering function cannot be set if the speed switch type is
set to “Push-type switch” in JW Smart Tune.
