Mounting set
LBM7013, LBM7113, LBM7213
__________________________________________________________________________________
__________________________________________________________________________________
Sida 5/9
INFO
The position of the wheelchair´s rear wheels can
affect the position of the screws (J) and holder
adapter bar (D). The positioning of the assembly
that pictures are showing can vary depending on
the position of the rear wheels of the wheelchair.
On the Cross 6 Long version it is most likely that
all the screws (J) will be positioned in front of the
wheelchair’s brakes.
Now mount the complete adapter bar
that consists of center pipe (A), outer
pipe (B) and clamp (C). The complete
adapter bar is mounted into the
holders (D) by using the QR-pins (E).
Make sure the ends of the outer pipe
(B) are parallell otherwise it can be
hard to assemble it into the holders
(D). It shall be possible to move the
center pipe sideways and also rotate
it if correctly assembled.
Now tighten all the screws (J) that holds the adapter plate in place.
INFO
Check that the arrow on the labeling mounted on the center pipe (A) is pointing towards the
front of the wheelchair. If the center pipe (A) is mounted the wrong way around it will not be
possible to attach Liberty to the bar.
D
J
M
