6
MAINTENANcE
warning: disconnect Power and
unPlug the Power cord before
attemPting any maintenance or
cleaning to reduce the risk of fire,
electric shock or damage
to Persons.
The bulbs in your unit can become extremely
hot. Allow at least 10 minutes between turning
off the unit and removing the light bulbs to
avoid the accidental burning of the skin.
risk of fire: do not exceed the
recommended bulb wattage.
rEplAcING THE
lIGHT BUlBS
Step 1: remove the 12 screws on the back
of fireplace and open the rear cover.
There are 2 larger screws and 10
smaller screws.
Step 2: You will find 1 x 40 W type B-10 bulb
under the log-set bed.
Step 3: loosen and remove the burnt out bulb
and replace with a new bulb.
Step 4: close the rear cover. Secure the
2 larger screws into the top left corner
hole and bottom right corner hole as
shown in the diagram. Secure the
10 smaller screws into the remaining
holes. Make sure the screws are
in the correct holes and have been
tightened.
Step 5: plug in the unit.
Larger screw
Larger screw
Bulb
clEANING
To clean the unit, first turn off all controls
on the unit and unplug the unit from power
source. To clean the glass display panel,
remove dust with a clean dry cloth, or remove
finger prints and other marks with clean
damp cloth. Do not use abrasive cleaners or
spray liquids on glass display panel surface.
Metal and metal painted parts should be
cleaned a with damp cloth. Do not use
abrasive cleaners or spray liquids on these
surfaces.
M A I N T E N A N c E
