Common faults and troubleshooting
Common faults
Fault code
E1/E2
Fault code HH
No power
Reason
Water temperature
sensor abnormal
Add hot water tem-
perature over 53 ° C,
anti-high temperature
burns protection start
Power plug is not
inserted
Make sure there is cold water, after power off and
restart, if still cannot be used normally, please contact
the seller for repair
Add cold water, the water temperature is reduced to
53 ° C, and the protection can eliminate
Plug the power plug according to the correct method
No heating
Not working or
stopped
working
halfway
Not boot, display "OFF"
No power
Power on, press the "Start" button, "OFF" display
eliminates
Plug the power plug according to the correct method
and start the machine
Timing time to the
automatic shutdown
Abnormal protection
shutdown (such as anti-
wire, anti-dry burning,
sensor abnormalities,
etc.)
restart the machine
Make sure there is cold water, after power off and
restart, if still cannot be used normally, please contact
the seller for repair
Elimination method
Scale
Special statement
This product has undergone a strict water test before leaving the factory, and a small amount of
water beads may remain in the product, which is normal and does not affect the quality of this
product, please use it with confidence. The drainage system design of this product can basically
exclude the residual water in the internal pipeline of the machine at the lowest point of the water
level. However, it is recommended to flush the inside of the cylinder with clean water after use to
prevent the breeding of bacteria.
Water is heavy or dirty
Flush after 10 minutes with white vinegar
09
08
If you need to add solid drugs in the bath, please wrap the drugs with gauze and
put them in the medicine box for use, so as not to block the filter screen and the
internal pipeline of the machine, resulting in machine failure;
Do not use the machine without water, it may damage the machine, and it may
be dangerous;
Do not use the machine standing up in order to avoid the danger of falling or
damaging the machine;
Do not operate the machine with wet hands and do not use the machine near
an open fire;
Precautions
