Dedicated Micros ©2007
SD Range
Global Alarms
Display mode
A monitor can be configured to switch to display mode on alarm
activation.
Post Alarm
Post alarm defines what happens when an alarm condition
has completed. Select Last to leave the last alarmed camera
displayed. Select Revert to return the display to its state prior to
the alarm being raised.
Camera fail
A relay can be assigned to activate if a camera fail is registered
by the DVR. This is hard defined as Relay 3.
Camera fail sounder
The on board sounder can be set to activate if a camera fail is
registered by the DVR.
Pre alarm (secs)
This is the period of time, prior to the alarm start that will be
included along with the alarm recording for archive. These images
will be protected from being overwritten with the alarm images
The unit places a ‘marker’ in the regular recording that acts as the
start of the pre-alarm recording, the number of images available
will be dependant on the pre-alarm time set.
Alarm entry/exit (secs)
The alarm entry/exit timer is the time interval between an entry
initiator being activated and alarms being triggered, or the alarm
keyswitch being tripped and the exit initiator being activated. This
timer will allow a key holder sufficient time to enter or exit the
premises without triggering an alarm. This is set in seconds.
Alarms (Red)
This button will navigate back to the main Alarms page.
Cancel (Purple)
Settings are automatically saved when the page is closed. Use
this button to cancel any changes before navigating away from
the page.
Save
To ‘manually’ save changes whilst in a menu page, select the
Save button.
