Status (parameter
)
Sub-status (parameter
)
= heating / cooling / domestic hot water
demand
= off
The set point is reached. The compressor can start up whenever necessary.
= anti-short cycle
The heating set point has been reached. The compressor is not authorised to
restart.
= reversal valve switch to heating position
= power supply to the hybrid pump
= pending start-up conditions on the heat pump and the back-ups
= three-way valve switch to domestic hot water position
= burner start-up
= opening of the flue gas valve / oil valve
= opening of the flue damper
= burner start-up
= pre-ignition
= boiler in heating mode
= nominal internal set point
= limited internal set point
= normal output check
= temperature stabilisation time
= operating in heating mode
= normal operation
The compressor or the back-ups are running.
= internal set point limited
If the heating set point on the heat pump differs from the system set point.
= pump post-operation
Heat pump and back-up shut-down, system pump operation.
= compressor bypass
The back-ups are operating.
= the temperature exceeds the compressor's maximum operating tem
perature
The compressor has stopped. The back-ups are operating.
= the outside temperature is lower than the compressor's maximum op
erating temperature
The compressor has stopped. The back-ups are operating.
= the hybrid function requests compressor shut-down
The compressor has stopped. The back-ups are operating.
= defrosting running
The compressor is running.
= defrosting conditions not met
The compressor has stopped. The back-ups are operating.
= defrosting running
The compressor and the back-ups are running.
= boiler in domestic hot water production
mode
= nominal internal set point
= limited internal set point
= normal output check
= temperature stabilisation time
6 Settings
44
200 ESL HYBRID
7613346 - v05 - 13112018
