9
2
2 / INSTALLING YOUR APPLIANCE
EN
ASSEMBLING THE HOOD
Note
The hood must be installed in compliance with all applicable regulations concerning the
ventilation of premises. In France these regulations are described in DTU 61.1 from the CSTB.
In particular, the evacuated air should never be carried to a duct used to evacuate smoke from
appliances that use gas or other combustible fuels. Disused ducts may only be used after
approval from a competent specialist.
The distance between the hob and the lowest part of the cooker hood must be between 50 and
65 cm (use the template supplied with your appliance).
- Draw a horizontal line at the chosen height.
- Position the drilling template against the wall, use wall plugs and screws suitable for your type of
wall.
- Drill the holes. Insert the wall plugs.
- Screw the attachment strip to the wall.
- Fully unscrew screws 2 to withdraw the hook as far as it will go.
- Locate the appliance on the strip.
- Tighten screws 2 up again until the appliance is clamped flat against the wall.
- Screw 1 is used to adjust the horizontal positioning of the cooker hood.
- Open the door of the hood, remove the cartridge filter, and put the anti-lift screws (3) in place.
-
Place the carbon filter in the filter cartridge with the 2 metal attachment brackets (see section
on changing the carbon filter).
-Secure the grid (4) in place with the 2 screws provided.
•
1
2
1
2
3
4
Summary of Contents for DHD 1193 W
Page 16: ...16 CZ5700919_00 09 11 ...
