46
EN
2
2 // INSTALLING YOUR APPLIANCE
To ensure leaktightness between the frame
and the worktop, stick the foam seal
around
the edge of the frame
.
Stick on the seal supplied in the plastic bag
before installing the hob:
1-
Remove the pan supports, the burner
covers and burner heads, noting their
positions.
2-
Turn the hob over and place it carefully over
the opening of the cabinet so as not to
damage the spark igniters.
3-
Stick the foam seal supplied with the
appliance in place
around the outside of the
frame
. This seal ensures leaktightness
between the glass and the worktop.
4-
Replace the burner heads, burner covers
and the pan supports.
B
UILDING THE HOB INTO A CABINET WITH A DOOR OR
DRAWER
(see diagram opposite).
Installing your hob above an oven requires a
front air inlet of at least 4 mm across the
entire width of the hob.
It is recommended that the hob not be
installed above an oven if the oven’s
ventilation is not frontwards.
Create an air vent in the partition to the right
or left of the oven, of at least 40 cm².
Note
The hob’s heat-safety features prevent
it being used while it is in pyrolysis mode.
Seal
Min 4mm
Gas hob
Front of
cabinet
Min
40 mm
Min 1
00 mm
Worktop
Min 40 cm²
