Page 11
PART # M-312 KD RV.8-2019-09-25
PEDESTAL TO FLOOR TEMPLATE
The Pedestal base is 8.0 inch (203 mm) square.
Each moun�ng hole is at a 0.5 inch (12.5 mm) from outer edges.
The recommended bolt length for moun�ng the pedestal is 1.5 inch (38 mm) to 2.0 inch (51 mm)minimum.
Drill four holes in the floor and install the pedestal with expansion bolt anchors and 3⁄8 inch (10 mm) machine bolts.
The inner circles on the template are intended to assist with moun�ng the pedestal to a wheel and �re.
Remember to seal the shaker to the pedestal with a non silicone elas�c sealant to prevent leaks and reduce noise.
The Pedestal includes six interior holes to mount
to a wheel and �re if desired. DO NOT use these
holes to mount the Pedestal to the floor,
damage will result. Use the outer holes in
Pedestal base to mount it to the floor.
