4 Set Up
Dedrone
14
IM-Inst-EK2536en
4.4
Cable Requirements and Preparation (Crimp)
Cable Requirements
Type
Cat-6 Patch Cable
Recommendation:
Cat-7 Patch Cable
Maximum Length
328 ft (100 m)
For longer distances, a PoE extender is required
External Diameter
3.5 mm – 7.5 mm
Cable Preparation
For a weather resistant LAN connection from your computer to the Tec Case, it is necessary to
crimp the supplied environmentally sealed Ethernet connector to the patch cable (not
included).
1
Cut the RJ45 plug off the laid cable. Keep the cut off plug, to check the wiring
standard later.
2
Thread the small gland nut, the bigger gland
nut and the connector body on to the cable.
3
Remove the cable jacket carefully. Therefore take care not to damage the braid and
foil.
4
Fold back the braid and foil over the cable jacket.
Note: 25 mm (1”) of free conductors are needed.
5
Unravel the conductors, sort the conductors
in the required wiring standard (568-A or 568-
B) and push the conductors all the way in the
plug.
The required wiring standard can be checked
on the previous cut-off RJ45 plug.
Position
568-A
568-B
1
White/Green White/Orange
2
Green
Orange
3
White/Orange White/Green
4
Blue
Blue
5
White/Blue
White/Blue
6
Orange
Green
7
White/Brown White/Brown
8
Brown
Brown
6
Crimp the RJ45 plug with the crimping tool.
7
Push down the latching clip of the plug and press the connector body all the way to
the stop over the RJ45 plug.
8
Put the bigger gland nut over the connector body and screw down the small gland
nut on the connector body.
1
Front Face View
