8
calorie between 10-990CAL. Press ON/OFF to start at speed of 1.0km/h.Speed
can be adjusted by pressing SPEED+,-. The machine stops when calorie shows 0.
3
3
3
3.2
.2
.2
.2 Getting
Getting
Getting
Getting Started
Started
Started
Started
Power the treadmill on by plugging it into an appropriate wall outlet, then turn on
the power switch located at the front of the treadmill below the motor shield.
Ensure that the
safety
safety
safety
safety key
key
key
key
is installed, as the treadmill will not power on without it.
When the power switch is turned on, the display is ready for operation.
3
3
3
3.3
.3
.3
.3 Self-Checking
Self-Checking
Self-Checking
Self-Checking
When using for the first time, it is necessary to make the machine carry on
self-check:
�
Remove the safety key, press
MODE
and hold, then insert the
safety key again, the machine enters into self-checking state. During this state,
pressing
ON/OFF
two times , the machine begins to self –check.
Incline motor goes to the top automatically, then goes to the bottom
automatically.
After that, 888 shows at the right of the display, press CLEAR/SET 3 seconds to
exit.
Note: Don’t stand on the machine when self-checking.
3
3
3
3.4
.4
.4
.4 Quick-Start
Quick-Start
Quick-Start
Quick-Start Operation
Operation
Operation
Operation
1. Press and release the
ON/OFF
to begin belt movement, at 1.0 Km/h, then
adjust to the desired speed using the ‘
+
’ or ‘
-
’. You may also use the quick
speed keys (3, 6 and 9) to adjust the speed.
2. To slow the treadmill down, press and hold the ‘speed
-
’ key to desired speed.
You may also press the rapid speed adjust keys: 3, 6, 9.
3. In a state of running, single press
ON/OFF
, the walking belt will gradually slow
down.
4. In the state of running, single press
CLEAR/SET
will reset time, distance,
calorie.
3
3
3
3.5
.5
.5
.5 Incline
Incline
Incline
Incline Feature
Feature
Feature
Feature
�
Incline may be adjusted anytime after belt movement.
�
Incline can’t be back to 0 after removing safety key.
�
Incline can be back to 0 after starting machine again.
