Introduction
Page 5 of 50
057-179 ISSUE: 3
1 INTRODUCTION
This document details the installation requirements of the DSE892 SNMP Gateway. The manual
forms part of the product and should be kept for the entire life of the product. If the product is passed
or supplied to another party, ensure that this document is passed to them for reference purposes.
This is not a
controlled document.
You will not be automatically informed of updates. Any future
updates of this document will be included on the DSE website at www.deepseaplc.com
DSE892 SNMP Gateway is used to connect with an SNMP V2c Community Based system to give
monitoring and control functionality.
DSE892 SNMP Gateway communicates to the connected controller(s), monitoring the instrumentation
and operating state. If this data changes, SNMP TRAP information is generated and sent to the
SNMP Manager. Additionally emails can be configured to be set to one or two email addresses.
DSE892 SNMP Gateway also supports GET functionality to read information from the host controller
and SET functionality to allow the SNMP manager to mimic button presses on the host controller.
Additionally, DSE892 SNMP Gateway contains a protocol conversion function.
For details on configuring the ‘host controller’ you are referred to the relevant configuration software
manual.
1.1 BIBLIOGRAPHY
This document refers to and is referred to by the following DSE publications which can be obtained
from the DSE website www.deepseaplc.com
DSE Part
Description
053-148
DSE892 installation instructions