LED SeaLite
®
Operator’s Manual
5
Safety Symbols
In this operator’s manual and on the product, safety symbols are used to communicate important
safety information. This section is provided to improve understanding of these symbols.
This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to
avoid possible injury or death.
DANGER
indicates a hazardous situation which, if not avoided, could result in death or serious injury.
WARNING
indicates a hazardous situation which, if not avoided, could result in damage to the product or bodily harm.
CAUTION
indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
NOTICE
indicates information that relates to the protection of property.
This symbol means read the operator’s manual carefully before using the equipment. The operator’s manual contains important information
on the safe and proper operation of the equipment.
This symbol means always wear safety glasses with side shields or goggles when handling or using this equipment to reduce the risk of
eye injury.
This symbol indicates the risk of electrical shock.
DANGER
!
WARNING
CAUTION
NOTICE
This symbol indicates a risk of exposure to high brightness.
UV and blue light can cause eye injury. Avoid exposure to eyes.
This symbol indicates high voltage.
This symbol indicates a potentially hot surface that may cause burns or ignition.
PRELIMIN
AR
Y
General Notes & Warnings
The LED SeaLite
®
light is designed and built for years of
reliable service.
This light was thoroughly pressure tested prior to leaving
the factory to confirm the integrity of the complete
assembly. While there should be no reason to repair the
LED SeaLite, this light is designed to be completely field
serviceable. No soldered wire connections or specialized
tools are required. All o-rings use viton material and
have an extended shelf life.
The LED SeaLite can run at full power in air. This light
is equipped with thermal sensing circuitry which will
automatically roll back the light output and prevent it
from overheating. The light will return to full brightness
once it is submerged and allowed to cool.
WARNING
Modifying the light in any way may damage the light and
void the warranty.
Do not clean any part of the light with solvent or alcohol.
Soapy water is recommended.
Reconfiguring the pin-out of the light is potentially
dangerous to the operator and can cause significant
damage to the light. Any change to the pin-out should
be done only through consultation with the factory in
order to provide proper documentation and new pin-
out labeling. Failure to do so will result in the loss of
warranty coverage for the light.
DANGER
When the LED SeaLite is operated in air, the light may
reach temperatures in excess of 65° C (150° F). These
temperatures may cause burns if the light is handled
without personal protective equipment.
While operating in air, this light emits sufficient photonic
energy to ignite combustible materials. When light is
operating in air, take appropriate precautions.
Do not operate any high voltage electrical equipment in
or around water without using proper safety equipment
such as a Ground Fault Circuit Interrupter (GFCI) and an
isolation transformer, especially when divers are in the
water.
