LED SeaLite
®
Operator’s Manual
6
All shipments should be sent to the address below:
DeepSea Power & Light
Attn: RMA ####
4033 Ruffin Road
San Diego, CA 92123-1817
U.S.A
Tel: 858-576-1261
Fax: 858-576-0219
Email: RMA@deepsea.com
Limited Warranty
Seller warrants that the goods (except internal electronic
components) sold under this contract will be free from
defect in material and workmanship for a period of two
years from the date of shipment from the factory, if they
have been properly used. Internal electronic components
are warranted for 90 days from the date of shipment
from the factory, if they have been properly used. This
warranty will be limited to the repair or replacement of
parts and the necessary labor and services required
to repair the goods. IT IS EXPRESSLY AGREED
THAT THIS WARRANTY WILL BE IN LIEU OF ALL
WARRANTIES OF FITNESS AND IN LIEU OF THE
WARRANTY OF MERCHANTABILITY. This warranty
is the exclusive and only warranty to pass with the
goods under this contract. No agent, employee, or
representative of the Seller has any authority to bind
Seller to any information, representation, or warranty
concerning the goods sold under this contract, and
unless an affirmation, representation, or warranty
made by an agent, employee, or representative is
specifically included within this contract, it will not be
enforceable by Buyer. If notice of defect is given to
DeepSea Power & Light, Inc. within such 90 day or two-
year warranty period, the sole obligation of DeepSea
Power & Light, Inc. shall be to furnish new or repaired
parts free of charge in exchange for parts which have
been proved defective and does not include any other
costs such as the cost of removal of the defective part,
installation, labor, or consequential damages of any
kind, the exclusive remedy being to require DeepSea
Power & Light, Inc. to furnish such new parts. Under
no circumstances shall the Buyer be entitled to recover
any incidental damages as that term is defined in
Commercial Code §2715.
Pre & Post Dive Inspection
Check to make sure that the rear bulkhead connector,
mating connector, and all mounting hardware are secure
before deployment.
Check the following areas for previous damage, wear,
or corrosion: rear bulkhead connector, power cable, and
front port.
Rinse the LED SeaLite in fresh water after use.
After each deployment, carefully check to make sure the
light is operational and has not flooded. If it has flooded,
the light can become internally pressurized upon
surfacing and create a potential danger. Additionally,
if the power remains on when the light has partially
flooded, it is possible for electrolytic generation of an
explosive mixture of hydrogen and oxygen gases. Point
the light away from persons and valuable equipment and
make sure that the power is disconnected.
Troubleshooting
If the light stops working while underwater, assume that
it has flooded.
If it has been determined that the light is not flooded,
and if the light does not turn on during pre-deployment
checks, check the input power cable/inline connector to
make sure that correct voltage is being supplied and that
the correct pin-out is being used. If the light still does
not work, return it to DSPL using the RMA Procedure for
Repair below.
RMA Procedure for Repair
For warranty and non-warranty repairs, please contact
DeepSea Power & Light for an RMA number prior to
returning the item. Please have the light model number,
serial number, and any other pertinent information along
with a description of the problem on hand when calling,
or include them in a fax or e-mail.
When shipping the item, be sure that the freight is pre-
paid (CODs will not be accepted) and that the RMA
number is clearly printed on the outside of the box.
www.deepsea.com
sales@deepsea.com
T: 800-487-3775
F: 858-576-0219
PRELIMIN
AR
Y
